Hi
I want to show You mine suction lines with evaps sets, some people have been asking me about it, so I decided to show You some ...YES, I make them for order ;-) .
Basicaly evap construction is like that on left ...but mine current design have 40 mm tall, and bit another canals inside ...on picture is mine rev 1.1
.
Brazed and polished evaporator
.
Brazed suction line which has gone to KumKum's unit .
Enclosure
.
Mine last suction line made, with K-probe attached, 13 mm insulation, 70 cm long for Peiponrang .
That's kit which I give to every suction line and evap set : stainless backplate, 19 mm and 6mm thick armaflex sheets, bolts set (80 mm long), some armaflex tape, 19 mm thick insulation for enclosure (no included on picture
) .
Feel free to sent me PM/e-mail with ask about suction line which You want ;-) (other colors of sleeves possible, braided lines, thicker insulation etc.) .
Regards
Peter